How to Adding Memory to MacBook Pro Manual Guide
This chapter provides information and instructions for installing additional memory and for removing and replacing the battery in your MacBook Pro. Your computer has two memory slots that you access by removing the memory door in the battery bay. Your MacBook Pro comes with a minimum of 512 megabytes (MB) of 667 MHz Double Data Rate (DDR2) Synchronous Dynamic Random-Access Memory (SDRAM) installed.
Both memory slots can accept an SDRAM module that meets the following specifications:
- Double Data Rate Small Outline Dual Inline Memory Module (DDR SO-DIMM) format
- 1.25 inch or smaller
- 512 MB or 1 gigabyte (GB)
- 200-pin
- PC2-5300 DDR2 667 MHz Type RAM
Depending on the configuration of the MacBook Pro you purchased, both memory slots might already be full.
The maximum amount of memory you can install in your MacBook Pro is 2 GB, using 1 GB DIMMs in both memory slots.
Dell Latitude 100L Service Manual PDF
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface : If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure. Align the notch in the module edge connector with the tab in the connector slot.
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it. If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet. As the computer boots, it detects the additional memory and automatically updates the system configuration information.
