The iMac G5 Repair Extension Program for Video and Power Issues applies to first generation iMac G5 computers that have video or power-related issues as a result of a specific component failure. If your iMac G5 is exhibiting any of the symptoms listed below and your computer’s serial number is within the noted ranges, your computer may be eligible for repair, free of charge.

If Apple or an Apple Authorized Service Provider (AASP) determines that your iMac G5 computer is eligible as part of the program, the repair will be covered by Apple for up to two years from the original date of purchase even if your iMac G5 is out of warranty. This is a worldwide Apple program. Affected systems will exhibit one of the following video- or power-related symptoms: Scrambled or distorted video No video No power

These instructions cover the iMac G5 (20-inch) models. The models may look slightly different from one shown in the illustration; however, the following procedure applies to both models.

Locate the three silver case screws circled below. You may have to lift the stand to locate the middle case screw. Note: These screws are captive; they are part of the display/bezel assembly and cannot be removed. Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws. Turn the screws to the left until they stop turning. Don’t force the screws once they stop turning.

To access the display/bezel assembly you must first remove other service modules. This procedure will show you how to remove and replace these modules. Note: As you remove each module, set it aside, along with the screws for that module. 2.Ground yourself. Touch the metal surface (as shown below) on the inside of the computer to discharge any static electricity. Warning: Always discharge static electricity before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk around the room until you have finished installing the part and closed the computer.

1.6GHz or 1.8GHz PowerPC G5 processor with Velocity Engine 512K on-chip level 2 cache at full processor speed 533MHz or 600MHz frontside bus 256MB of PC3200 (400MHz) DDR SDRAM expandable to 2GB; two memory slots storage 80 or 160GB 7200-rpm Serial ATA hard disk drive

One of the following optical drives: Combo drive (DVD-ROM/CD-RW): reads DVDs at up to 8x speed, writes CD-R discs at up to 24x speed, writes CD-RW discs at up to 16x speed, reads CDs at up to 24x speed SuperDrive (DVD-R/CD-RW): writes DVD-R discs at up to 4x speed, reads DVDs at up to 8x speed, writes CD-R discs at up to 16x speed, writes CD-RW discs at up to 8x speed, reads CDs at up to 24x speed ommunications

3 Built-in 56K V.92 modem (RJ-11 connector) Built-in 10/100BASE-T Ethernet (RJ-45 connector) Built-in antennas and expansion slot for optional 54-Mbps AirPort Extreme Card (based on IEEE 802.11g 3 standard; Wi-Fi Certified for 802.11g and 802.11b interoperability) Optional internal Bluetooth module

The first in a series of how to fix an iMac G5 mother board. See how to fix an iMac G5 power supply. I had to get the lead out when it comes to repairing the Apple iMac G5 PPC motherboard problems. Beware, don’t try this replacing capacitors on an iMac repair yourself, unless you have help or experience with all types of handy tools at your disposal, or willing to take a challenge.

Also, beware of the time commitment involved with this Apple computer repair. “Be prepared,” is the old Boy Scout motto, and that is no lie when it comes to tackling this Apple product repair yourself. See below if your Apple serial number is covered.

Remote Director is the first collaborative video-based “soft proofing” system that works in a fully color-managed environment. Using custom monitor calibration and profiling techniques along with industry- standard ICC output profiles and the Apple iMac G5 computer, Remote Director can accurately soft proof all SWOP based printing environments.

CPU: Apple iMac G5 with 500 MB SDRAM, or better Monitor: Built-in 20” Display (hereafter “iMac G5”) Monitor Calibration Instruments: GretagMacbeth Eye-One Monitor, Eye-One Photo or Eye-One Pro (without UV filter.) Monaco OPTIX XR by X-Rite, Inc Network Connectivity: Cable/DSL Network access minimum, 1 Mbps Cable or T1 and firewall with access to port 443 and outbound only on port 7798 recommended Software: Mac OS X 10.3.6 or later ICS Remote Director 3.0 or later Viewing booth: A variable-intensity monitor-side viewing station with D50 reflective lighting.

Your iMac G5 has been designed so that you can set it up quickly and start using it right away. If you have never used an iMac G5 or are new to Macintosh computers, read this section for instructions on getting started. If you are an experienced user, you may already know enough to get started. Be sure to look over the information in Chapter 2, Getting to Know Your iMac G5 to find out about the new features of this iMac G5.

Using a Wireless Keyboard and Mouse If you purchased an Apple Wireless Keyboard and Apple Wireless Mouse with your iMac G5, see the instructions that came with the keyboard and mouse to set them up with your computer.